Line 14: |
Line 14: |
| |Has model=Spectrum 875 | | |Has model=Spectrum 875 |
| |Has serial number=MJ324002P | | |Has serial number=MJ324002P |
− | |Has ace=Needed;Needed | + | |Has ace=Levi Gibson;lgibson19@georgefox.edu |
| }} | | }} |
| [[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|140px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]] | | [[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|140px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]] |
Line 27: |
Line 27: |
| | | |
| Location: {{#show: {{PAGENAME}} |?Is located in facility}} | | Location: {{#show: {{PAGENAME}} |?Is located in facility}} |
| + | |
| + | |
| + | ==Safety First== |
| + | [[File:Safety First HD2.png|left|150px]] |
| + | Here are some safety instructions for the {{PAGENAME}}. Remember... SAFETY FIRST!!! |
| + | * Only cut steel and aluminum. |
| + | * Never cut any coated materials |
| + | * Don't attempt to cut with the compressed air off |
| + | * Make sure the vent hood is on and placed near your working area. This will help evacuate the smoke. |
| + | * Arc rays can burn your eyes and skin. Wear a welding helmet and there should be no bare skin exposed. |
| + | * Never walk on the hoses or ground cable as this could cause damage to the machine. |
| + | * Never pull the trigger on the torch unless you are cutting material as this will reduce the life of the nozzle and electrode. |
| | | |
| | | |
Line 86: |
Line 98: |
| # Disconnect the ground clamp. | | # Disconnect the ground clamp. |
| # Reset the space! | | # Reset the space! |
− |
| |
− | ==Safety==
| |
− | # Only cut steel and aluminum.
| |
− | # Never cut any coated materials
| |
− | # Don't attempt to cut with the compressed air off
| |
− | # Make sure the vent hood is on and placed near your working area. This will help evacuate the smoke.
| |
− | # Arc rays can burn your eyes and skin. Wear a welding helmet and there should be no bare skin exposed.
| |
− | # Never walk on the hoses or ground cable as this could cause damage to the machine.
| |
− | # Never pull the trigger on the torch unless you are cutting material as this will reduce the life of the nozzle and electrode.
| |
| | | |
| ==Certification== | | ==Certification== |