1,956
edits
Changes
Jump to navigation
Jump to search
Line 77:
Line 77: − + − + − +
→General Procedure
# Adjust your speed so the sparks go thru the metal and out the bottom of the cut. Cutting too fast could prevent the cut from going all the way through in some areas.
# Adjust your speed so the sparks go thru the metal and out the bottom of the cut. Cutting too fast could prevent the cut from going all the way through in some areas.
# At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger as this will give you a complete cut.
# At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger as this will give you a complete cut.
# Turn off machine
# Turn off machine.
# Turn off air
# Disconnect the compressed air line.
# Disconnect ground clamp
# Disconnect the ground clamp.
# Reset the space!
# Reset the space!