1,962
edits
Changes
Jump to navigation
Jump to search
→Troubleshooting
Line 82:
Line 82:
# Suppose the machine will not stop.
−## This is a very rare occurrence, as the machine is designed to be fail-safe. If it should occur and you cannot fix the fault, seek professional assistance. The machine must be disconnected from the power and never run until the fault has been rectified.
−# Suppose the motor tries to start but will not turn.
−## Typical reasons are: guides too tight, wood jammed in the wheel. Adjust guides or remove jammed wood.
−## Feeding the wood too fast. Slow down the feed rate.
−## Insufficient set on the teeth (wood nipping the blade). Change blade for a blade with the correct set.
−## Oil or dirt on the drive belt. Clean or replace the drive belts.
−## Fence not aligned correctly. Align fence.
−# Suppose the blade will not track on flywheels.
−## Bad blade. Change the blade.
−## Crown on the wheels worn or damaged tire. Dress the tires.
−# Suppose the blade kicks.
−## Bad blade. Replace the blade.
# Suppose the bandsaw will not start.
# Suppose the bandsaw will not start.
## Check that the E-stop is fully pulled out.
## Check that the E-stop is fully pulled out.
−## Check that the electrical power cord is plugged into the power outlet.
+## Check that the electrical power cord is plugged into the power outlet.
−==Maintenance==
==Maintenance==