Line 134: |
Line 134: |
| ## Press "Enter" to close the tray. [[File:bake_go.jpg|300x300px|none]] <br /> | | ## Press "Enter" to close the tray. [[File:bake_go.jpg|300x300px|none]] <br /> |
| ## The preheat will take 2 minutes. The baking process takes about 30 min. [[File:bake_inside.jpg|300x300px|none]] <br /> | | ## The preheat will take 2 minutes. The baking process takes about 30 min. [[File:bake_inside.jpg|300x300px|none]] <br /> |
− | ## '''The drawer will automatically open to initiate the cool down phase. DO NOT remove the board until the oven says all the stages are complete. DANGER: The rails are HOT!''' | + | ## The drawer will automatically open to initiate the cool down phase. '''DO NOT remove the board until the oven says all the stages are complete. DANGER: The rails are HOT!''' |
| ## When cool down is complete, remove the board from the oven. <br /> <br /> | | ## When cool down is complete, remove the board from the oven. <br /> <br /> |
| #''Preparing for Solder Paste'' | | #''Preparing for Solder Paste'' |
− | ##Take a barnishing pad from one of the drawers. | + | ##Take a burnishing pad from one of the drawers. |
− | ##Rub the substrate until the traces have a shine to them, rather than a dull apprentice. | + | ##Rub the substrate with the pad until the traces have a shine to them, rather than a dull appearance. |
− | ##Replace the barnishing pad back into the drawer | + | ##Replace the burnishing pad back into the drawer |
− | #Clever title for this section | + | #''The Solder Paste'' |
− | ##At this time, retreive the solder paste from the fridge and set it out to warm | + | ##At this time, retrieve the solder paste from the fridge and set it out to warm |
| ##Take the board back to the Voltera | | ##Take the board back to the Voltera |
| ##Clamp the board into place. | | ##Clamp the board into place. |
| ##Open the volteraapp and choose "Solder" | | ##Open the volteraapp and choose "Solder" |
| ##Choose the proper paste, in this case you want the orange labeled paste | | ##Choose the proper paste, in this case you want the orange labeled paste |
− | ##'''Edit the gerber so that theres no solder paste on pads''' | + | ##'''NICK: we need to edit the gerber so that theres no solder paste on pads''' |
| ##'''Like before, clean the calibration switches''' | | ##'''Like before, clean the calibration switches''' |
| ##Mount the probe, next | | ##Mount the probe, next |