Changes

## Press "Enter" to close the tray. [[File:bake_go.jpg|300x300px|none]] <br />

## Press "Enter" to close the tray. [[File:bake_go.jpg|300x300px|none]] <br />

## The preheat will take 2 minutes. The baking process takes about 30 min. [[File:bake_inside.jpg|300x300px|none]] <br />

## The preheat will take 2 minutes. The baking process takes about 30 min. [[File:bake_inside.jpg|300x300px|none]] <br />

## '''The drawer will automatically open to initiate the cool down phase. DO NOT remove the board until the oven says all the stages are complete. DANGER: The rails are HOT!'''

## The drawer will automatically open to initiate the cool down phase. '''DO NOT remove the board until the oven says all the stages are complete. DANGER: The rails are HOT!'''

## When cool down is complete, remove the board from the oven. <br /> <br />

## When cool down is complete, remove the board from the oven. <br /> <br />

#''Preparing for Solder Paste''

#''Preparing for Solder Paste''

##Take a barnishing pad from one of the drawers.

##Take a burnishing pad from one of the drawers.

##Rub the substrate until the traces have a shine to them, rather than a dull apprentice.

##Rub the substrate with the pad until the traces have a shine to them, rather than a dull appearance.

##Replace the barnishing pad back into the drawer

##Replace the burnishing pad back into the drawer

#Clever title for this section

#''The Solder Paste''

##At this time, retreive the solder paste from the fridge and set it out to warm  

##At this time, retrieve the solder paste from the fridge and set it out to warm  

##Take the board back to the Voltera

##Take the board back to the Voltera

##Clamp the board into place.

##Clamp the board into place.

##Open the volteraapp and choose "Solder"

##Open the volteraapp and choose "Solder"

##Choose the proper paste, in this case you want the orange labeled paste

##Choose the proper paste, in this case you want the orange labeled paste

##'''Edit the gerber so that theres no solder paste on pads'''

##'''NICK: we need to edit the gerber so that theres no solder paste on pads'''

##'''Like before, clean the calibration switches'''

##'''Like before, clean the calibration switches'''

##Mount the probe, next

##Mount the probe, next