Changes

*Regenerative Blower- This device produces the vacuum needed to pull material down onto the spoil board.   

*Regenerative Blower- This device produces the vacuum needed to pull material down onto the spoil board.   

*Tool Holder- Cutters are placed in the tool holder and each holder gets pulled into the spindle during a tool change.

*Tool Holder- Cutters are placed in the tool holder and each holder gets pulled into the spindle during a tool change.

*Up Shear Router Bits- Normally used for deeper pockets as they evacuative chips better.

*Up Shear Router Bits-

*Down Shear Router Bits- Normally used for shallow pockets and leaves a very clean edge. Tend to pile up the chips as they don't evacuate the chips very well. 

*Down Shear Router Bits-

*Combination (Compression) Router Bits- Helps keep a good finish on the material when using a laminate on both sides. 

*Combination (Compression) Router Bits-

*Tool Touch-Off- A process of setting the Z axis height of a tool using the sensor built into the machine.   

*Tool Touch-Off- A process of setting the Z axis height of a tool using the sensor built into the machine.