1,956
edits
Changes
Jump to navigation
Jump to search
Line 82:
Line 82: − + − # Suppose the machine will not stop. − ## This is a very rare occurrence, as the machine is designed to be fail-safe. If it should occur and you cannot fix the fault, seek professional assistance. The machine must be disconnected from the power and never run until the fault has been rectified. − # Suppose the motor tries to start but will not turn. − ## Typical reasons are: guides too tight, wood jammed in the wheel. Adjust guides or remove jammed wood. − ## Feeding the wood too fast. Slow down the feed rate. − ## Insufficient set on the teeth (wood nipping the blade). Change blade for a blade with the correct set. − ## Oil or dirt on the drive belt. Clean or replace the drive belts. − ## Fence not aligned correctly. Align fence. − # Suppose the blade will not track on flywheels. − ## Bad blade. Change the blade. − ## Crown on the wheels worn or damaged tire. Dress the tires. − # Suppose the blade kicks. − ## Bad blade. Replace the blade.
→Troubleshooting
# Suppose the bandsaw will not start.
# Suppose the bandsaw will not start.
## Check that the E-stop is fully pulled out.
## Check that the E-stop is fully pulled out.
## Check that the electrical power cord is plugged into the power outlet.
## Check that the electrical power cord is plugged into the power outlet.
==Maintenance==
==Maintenance==