1,956
edits
Changes
Jump to navigation
Jump to search
Line 87:
Line 87: − # Suppose the motor overheats. − ## The motor is designed to run very hot, but should it overheat it has an internal terminal overload protector that will shut it down until the motor has cooled down and then it will reset automatically. If the motor overheats, wait until it has cooled down and restart. If the motor shuts down constantly, check for the reason. Typical reasons are dull blade, overfeeding the wood, motor cooling fan clogged or faulty, motor cooling fins clogged and excessive ambient temperature. − # Suppose there's a squeaking noise. − ## Check that the motor cooling fan is not contacting the fan cover. − ## Check the drive belt. − ## Check that the guides are adjusted correctly. − # Suppose the upper guide shaft is tight or loose. − # Suppose the blade slows down during a cut. − ## Loose drive belt. Re-tension the belt. − ## Dull blade. Replace the blade or have it re-sharpened.
→Troubleshooting
# Suppose the motor tries to start but will not turn.
# Suppose the motor tries to start but will not turn.
## Typical reasons are: guides too tight, wood jammed in the wheel. Adjust guides or remove jammed wood.
## Typical reasons are: guides too tight, wood jammed in the wheel. Adjust guides or remove jammed wood.
## Feeding the wood too fast. Slow down the feed rate.
## Feeding the wood too fast. Slow down the feed rate.
## Insufficient set on the teeth (wood nipping the blade). Change blade for a blade with the correct set.
## Insufficient set on the teeth (wood nipping the blade). Change blade for a blade with the correct set.