2,297
edits
Changes
Jump to navigation
Jump to search
Line 89:
Line 89: − [[File:Foam2.png|400px|thumb|right]] +
→Operation
''Assembling the THERMOCUT''
''Assembling the THERMOCUT''
# Fit the overarm 1 (Fig. 2) underneath the device by using the enclosed knurled screw.
# Fit the overarm 1 (Fig. 2) underneath the device by using the enclosed knurled screw.
# Fasten the cable 2 to the overarm with the screw 3.
# Fasten the cable 2 to the overarm with the screw 3.
# Tighten the screw well to ensure good electrical contact (10.5 volt low voltage).
# Tighten the screw well to ensure good electrical contact (10.5 volt low voltage).
# Slide the spool carrier 8 (Fig. 1) on to the arm and fasten it with the screw 9.
# Slide the spool carrier 8 (Fig. 1) on to the arm and fasten it with the screw 9.
[[File:Foam2.png|400px|none]]
''Installing the cutting wire''
''Installing the cutting wire''