2,292
edits
Changes
Jump to navigation
Jump to search
Line 211:
Line 211: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
no edit summary
[[File:TW33.1.png|1500px|none]]
[[File:TW33.1.png|1500px|none]]
[[File:TW33.2.png|1500px|none]]
[[File:TW33.2.png|1500px|none]]
<br>
<br>
==Wood Shop==
<strong>Step 34:</strong> Cut a 1.5x1.5x9.5 inch square column on the [[Table Saw|table saw]]. You don't have to shorten the workpiece to 9.5 inches just yet, but it will make the work on the wood drill press much easier.
TW34
<br>
<br>
<strong>Step 35:</strong> Cut the four holes using the [[Wood Drill Press|wood drill press]].
TW35
<br>
<br>
<strong>Step 36:</strong> Mark the areas that will be cut out on the side of the train whistle.
TW36
<br>
<br>
<strong>Step 37:</strong> Cut the four triangular pieces using the [[Wood Bandsaw|wood bandsaw]].
TW37
<br>
<br>
<strong>Step 38:</strong> Flatten a length of 1/2-inch wooden dowel down to 3/8 inch using the [[Disc/Belt Sander|disc/belt sander]]. Cut the flattened dowel into four pieces a bit longer than you will need for the fipple blocks using the wood bandsaw.
TW38
<br>
<br>
<strong>Step 39:</strong> Test the fipple blocks before gluing. Take note of the placement of each fipple block that gives the best sound for each hole. You can use a bit of extra wooden dowel to hold them in place.
TW39
<br>
<br>
<strong>Step 40:</strong> Glue the fipple blocks in place and use a bit of extra wooden dowel to hold them in place. Let the glue sit overnight before working on the train whistle body again.
TW40
<br>
<br>
<strong>Step 41:</strong> Cut a 1.5x1.5x0.75 inch block for the mouthpiece. Use a 1 3/8 Forstner bit and a 1/2 drill bit for the holes in the mouthpiece.
TW41
<br>
<br>
<strong>Step 42:</strong> After the glue has dried, use the wood bandsaw and the belt/disc sander to remove the extra length of the fipple blocks.
TW42
<br>
<br>
<strong>Step 43:</strong> Glue the mouthpiece on top of the train whistle body and let it sit overnight. Once the glue has dried, your train whistle is ready to make some noise. Feel free to sand the edges down, hand-carve or burn-in a design, stain the wood, apply lacquer/finish, and/or engrave something on it using the [Laser Cutter|laser cutters]]. Enjoy!
TW43
<br>
<br>
<br>
<br>