2,292
edits
Changes
Jump to navigation
Jump to search
Line 139:
Line 139: − + − + − + + + + + + + + + + + + + + + +
→Fipple Block
===Fipple Block===
===Fipple Block===
<strong>Step 21:</strong> .
<strong>Step 21:</strong> Begin a new SolidWorks part for the fipple block. Ensure your units in the bottom right corner are IPS. Begin a sketch in the top plane and draw a circle that is centered on the origin. Use the Smart Dimension tool to set the circle's diameter to 1/2 inch.
TW21
TW21
<br>
<br>
<br>
<br>
<strong>Step 22:</strong> .
<strong>Step 22:</strong> Draw a construction line from the top-most point of the circle through the origin. Use the Smart Dimension tool to set the length of this line to 3/8 inch (0.375 inch).
TW22
TW22
<br>
<br>
<br>
<br>
<strong>Step 23:</strong> .
<strong>Step 23:</strong> Use the drop-down menu for a line and select a midpoint line. Draw a midpoint line starting from the bottom point of the construction line horizontally to the edge of the circle. It should span across the circle as shown in the screenshot below.
TW23
TW23
<br>
<br>
<strong>Step 24:</strong> Use the Trim Entities tool to chop off the bottom part of the circle underneath the midpoint line.
TW24
<br>
<br>
<strong>Step 25:</strong> Go to the Features tab and click on Extruded Boss/Base. Set the height (or depth) to 3/4 inch and click the green checkmark when you are finished.
TW25
<br>
<br>
<strong>Step 26:</strong> You should have a flattened dowel like the one shown in the screenshot below.
TW26
<br>
<br>
<br>
<br>