1,956
edits
Changes
Jump to navigation
Jump to search
Line 59:
Line 59: − + + + + + + + + + + + + + +
→General Procedure
====General Procedure====
====General Procedure====
Basic Setup
'''Basic Setup'''
1. Connect the motor bracket to the stand clip if not already done.
2. Remove and install the desired handpiece if needed. See video for removal and installation. Make sure the shaft key is properly aligned before installation.
3. Change the tool if needed. Use the locking pin and wrench to tighten and looses the collet. Make sure to remove the locking pin when done.
4. Place the variable speed foot pedal at a comfortable position on the floor.
5. Plug in the power cord.
6. Set the motor direction switch for proper rotation direction. Most tools should be used in the forward direction. Ask if you are unsure about the motor direction.
7. Make sure you have a good grip on the handle before pressing the foot pedal as the cutting tool will begin to spin. The speed of the tool is proportional to the travel of the foot pedal.
==Safety==
==Safety==