1,956
edits
Changes
Jump to navigation
Jump to search
Line 74:
Line 74: − [[File:TABLE_SAW_CONTROLS.jpg|none|thumb|600x600px]]+ − + − − 2. Place the cross cut sled on the table by aligning the table slots with the rails on the sled. − − 3. Slide the sled over the blade and use the material to set the blade height using the blade height handle on the front of the saw. The blade should be roughly one tooth taller than the top of the material. − − 4. Place the material flat edge against the back of the sled and align the material with the edge of the blade. − − 5. Once the blade is clear pull the red paddle switch to turn on the saw. − − 6. Slide the sled forward to cut through the material at the desired location. − − 7. Slide the sled back to you so it clears the blade. − − 8. Power down the saw by pressing the red paddle switch located on the front of the machine. − − 9. Lower the blade below the table using the crank handle on the front of the machine. − − 10. Reset the space by cleaning up any dust, turning off the equipment, and lowering the blade below the table to keep anyone from accidentally cutting themselves.
→General Procedure
====General Procedure====
====General Procedure====
'''Cross Cut'''
'''Cross Cut'''
1. Move the fence off to the side by lifting the brake handle and sliding the fence off to the side.
1. Move the fence off to the side by lifting the brake handle and sliding the fence off to the side.
==Safety==
==Safety==