411
edits
Changes
Jump to navigation
Jump to search
Line 43:
Line 43: − +
→Overview
==Training==
==Training==
====Overview====
====Operation====
Begin by clamping your piece down with the vice. The exact positioning of the piece is not critical because it can be changed later with the x-y adjustments. Do not try to drill without the piece being clamped or it may catch and turn into a spinning blade. It is also possible to twist and raise the work table if needed. Insert the desired drill bit into the chuck and tighten it with the chuck key. Make sure the bit is centered in the chuck and that there is at least a 1/8" gap between the bottom of the chuck and the end of the drill's grooves. Note that you should start the hole with the hole starter tool before using the actual bit. Fine tune the position of the piece using the x-y adjustments and turn on the drill press with the start button. Adjust the speed to match the material you are drilling. You can find the correct speed on the chart above the mills. Also, ONLY adjust the speed while the drill press is ON to prevent damage to the drill press. Now you can drill your hole. For optimal results, lubricate the cutting area with machining oil before drilling a use peck drilling, i.e. drilling down a small amount, lifting out the bit to clear scraps from the hole, and then repeating. Don't forget to reset the space by cleaning up any metal chips and returning any drill bits that were used during the process.
Begin by clamping your piece down with the vice. The exact positioning of the piece is not critical because it can be changed later with the x-y adjustments. Do not try to drill without the piece being clamped or it may catch and turn into a spinning blade. It is also possible to twist and raise the work table if needed. Insert the desired drill bit into the chuck and tighten it with the chuck key. Make sure the bit is centered in the chuck and that there is at least a 1/8" gap between the bottom of the chuck and the end of the drill's grooves. Note that you should start the hole with the hole starter tool before using the actual bit. Fine tune the position of the piece using the x-y adjustments and turn on the drill press with the start button. Adjust the speed to match the material you are drilling. You can find the correct speed on the chart above the mills. Also, ONLY adjust the speed while the drill press is ON to prevent damage to the drill press. Now you can drill your hole. For optimal results, lubricate the cutting area with machining oil before drilling a use peck drilling, i.e. drilling down a small amount, lifting out the bit to clear scraps from the hole, and then repeating. Don't forget to reset the space by cleaning up any metal chips and returning any drill bits that were used during the process.