Changes

====General Procedure====

====General Procedure====

# Setup

# Setup

## First we have to Preheat the mold. If a hot plate is available, preheat the aluminum mold to prevent plastic cooling too fast by placing the mold on the hot plate and heating to a specific temperature. Temperatures for different plastics can be found in the table below.[[File:...injectionTemperatureChart.png|none|thumb|373x373px]] [[File:...Temp_Controller.JPG|none|thumb|373x373px]]

## First we have to Preheat the mold. If a hot plate is available, preheat the aluminum mold to prevent plastic cooling too fast by placing the mold on the hot plate and heating to a specific temperature. Temperatures for different plastics can be found in the table below.[[File:...injectionTemperatureChart.png|none|thumb|373x373px]] [[File:Temp_Controller.JPG|600px|thumb|none]]

 

## Next we need to adjust the height by following these steps.  

## Next we need to adjust the height by following these steps.  

### Set the mold clamps to measure the gap.  

### Set the mold clamps to measure the gap.