1,962
edits
Changes
Jump to navigation
Jump to search
→General Procedure
Line 65:
Line 65:
### Loosen the height adjustment bolts on the top holder using a 6mm Allen Wrench.
### Loosen the height adjustment bolts on the top holder using a 6mm Allen Wrench.
### Loosen both tension nuts, and turn the lower tension nut to move the top holder up and down the main post. This will determine the height of the machine.
### Loosen both tension nuts, and turn the lower tension nut to move the top holder up and down the main post. This will determine the height of the machine.
−### Raise or lower the top holder so that there is a gap between the nozzle and the mold (this allows adding and removing the mold), but of no more than ½”.
+### Raise or lower the top holder so that there is a gap between the nozzle and the mold sprue (this allows adding and removing the mold), but of no more than ½”.
### Tighten height adjustment bolts, and verify that the nozzle aligns well with the mold sprue.
### Tighten height adjustment bolts, and verify that the nozzle aligns well with the mold sprue.
### Tighten the upper and lower tension nuts.
### Tighten the upper and lower tension nuts.