1,956
edits
Changes
Jump to navigation
Jump to search
Line 130:
Line 130: − + Line 154:
Line 154: − + + +
→General Procedure
1. Place the plate with the installed pin on top of the table support plates. You will need to leave a gap between the plates for the pin to press though.
1. Place the plate with the installed pin on top of the table support plates. You will need to leave a gap between the plates for the pin to press though.
[[File:HP Step 4.jpg|none|thumb]]
[[File:HP Step 6.jpg|none|thumb]]
2. Check the distance between the end of the pin to be pressed and the ram. If the gap is too large the ram will run out of travel before pressing out the pin.
2. Check the distance between the end of the pin to be pressed and the ram. If the gap is too large the ram will run out of travel before pressing out the pin.
12. Insert the pump handle into the handle socket.
12. Insert the pump handle into the handle socket.
13. Slowly cycle the handle while watching the force gauge and the pin. Make sure the pin is starting to move.
13. Slowly cycle the handle while watching the force gauge and the pin. Make sure the pin is starting to move.
[[File:HP Step 8.jpg|none|thumb]]
15. You will continue to press the pin until the pin is flush with the top of the material.
15. You will continue to press the pin until the pin is flush with the top of the material.