80
edits
Changes
Jump to navigation
Jump to search
Line 78:
Line 78: − + + +
→General Procedure
5) Insert the 6" rod between the radius pin and the die and tighten the cam such that the 1/8" mark is tangent to the die. It is a tight fit so rocking the radius pin back and forth may be necessary to adjust properly.
5) Insert the 6" rod between the radius pin and the die and tighten the cam such that the 1/8" mark is tangent to the die. It is a tight fit so rocking the radius pin back and forth may be necessary to adjust properly.
6) Using the 3/4" wrench adjust the
6) As needed, use the 3/4" wrench adjust the adjusting bolt such that the locking pin does not interfere with the path of the forming nose. The middle position should work.
7) Bend the rod until the center mark on the rod barely touches the radius pin. The rod will spring back so a slight over-bend is necessary.
==Safety==
==Safety==
*Keep all hands and fingers out of any pinch points.
*Keep all hands and fingers out of any pinch points.