Changes

=== Rolling Steps ===

=== Rolling Steps ===

#Adjust the radius by turning the knobs on the back of the machine.

#Adjust the radius by turning the knobs on the back of the machine. This adjusts the distance between the rollers.

#Adjust the tension using the knobs on the front left of the machine for materials of different sizes.

#Adjust the amount of pinch using the knobs on the front left of the machine for materials of different thickness.  If the gap between the rollers is too far apart the material will slip on the rollers.

#Begin by pulling the right side of the top roller out of its slot.

#Begin by pulling the right side of the top roller out of its slot.

#Insert your piece that you would like to roll between the rollers.

#Insert your piece that you would like to roll between the rollers.

#Re-secure the top roller inside of the slot prior to rolling.

#Re-secure the top roller inside of the slot prior to rolling.

#Crank the crank slowly till you have rolled to the desired radius. If the initial radius is not the desired radius, re-roll at a slightly larger radius. Try to limit the number of rolls as to not put too much unnecessary stress on the sheet metal.

#Slowly rotate the handle until you have rolled to the desired radius. If the initial radius is not the desired radius, re-roll at a slightly tighter radius.

#Remove the top roller to take your rolled metal out of the roller.

#Unlock the top roller to slide your rolled metal off the end of roller.

== 3 commandments ==

== 3 commandments ==