1,956
edits
Changes
Jump to navigation
Jump to search
Line 74:
Line 74: − +
→Operation
====Operation====
====Operation====
The hand router is very versatile and can accommodate 2 different cutter shank diameters. Both the 1/4" and 1/2" shank require their own specific collet. The collet is removed by unscrewing the collet clamping nut and removing the collet. The collet is located near the cutter so it tends to collect a large amount of wood dust. It's important to always clean out the collet and collet housing so the spring clamping action of the collet works properly. It is also very important to have the proper amount of cutter shank engagement into the collet. A cutter shank that is not installed correctly could come loose or even damage the collet. You should have at least 3/4" engagement of the shank into the collet. You should install the cutter and slide it all the way into the collet then pull it out approximately 1/8". This will make sure the shank is not bottomed out in the collet.
The hand router is a versatile power tool and can accommodate 2 different cutter shank diameters. Both the 1/4" and 1/2" shank require their own specific collet. The collet is removed by unscrewing the collet clamping nut and removing the collet. The collet is located near the cutter so it tends to collect a large amount of wood dust. It's important to always clean out the collet and collet housing so the spring clamping action of the collet works properly. It is also very important to have the proper amount of cutter shank engagement into the collet. A cutter shank that is not installed correctly could come loose or even damage the collet. You should have at least 3/4" engagement of the shank into the collet. You should install the cutter and slide it all the way into the collet then pull it out approximately 1/8". This will make sure the shank is not bottomed out in the collet.
If your material looks good, the next step is to set up the router itself. When setting up the router height,
If your material looks good, the next step is to set up the router itself. When setting up the router height,