Changes

#* Now we come to support! Support is extra material printed around your model to support tougher geometric angles that the printer can't get to on its own. It is easily torn off at the end of the print.

#* Now we come to support! Support is extra material printed around your model to support tougher geometric angles that the printer can't get to on its own. It is easily torn off at the end of the print.

#* The Brim option is for bed adhesion. You will typically want this option, since it helps prevent the warping of the part you are printing. A brim is most important for prints that have a small surface area that is in contact with the plate.

#* The Brim option is for bed adhesion. You will typically want this option, since it helps prevent the warping of the part you are printing. A brim is most important for prints that have a small surface area that is in contact with the plate.

# When all those settings are complete, you can click "Generate" in the bottom right corner, and Slicer will give you a time and filament estimate for your print. If they seem reasonable, you can save the newly "sliced" .gcode file to the SD card that will go into the printer! If not, you can always go back and adjust the settings to fit your time and/or filament needs.  

# When all those settings are complete, you can click "Slice now" in the bottom right corner, and Slicer will give you a time and filament estimate for your print. If they seem reasonable, you can save the newly "sliced" .gcode file to the SD card that will go into the printer! Do this by clicking  "Export G code." You can always go back and adjust the settings to fit your time and/or filament needs before saving the file.  

Starting a Print:  

Starting a Print:  

# Thoroughly clean the build plate with isopropyl alcohol and a paper towel.  

# Thoroughly clean the build plate with isopropyl alcohol and a paper towel.