479
edits
Changes
Jump to navigation
Jump to search
Line 31:
Line 31: − Oven Rack LCD Display+ Line 46:
Line 46: − + + + + + + + + − + − + +
→General Procedure
====Terminology====
====Terminology====
Tray LCD Display
* [https://www.lpkfusa.com/products/pcb_prototyping/smt_assembling/protoflow_s/ Product Home Page]
* [https://www.lpkfusa.com/products/pcb_prototyping/smt_assembling/protoflow_s/ Product Home Page]
====General Procedure====
====General Procedure====
# Power the Reflow Oven on.
# Select the respective ink/paste. Recall, Green is V1 Ink, Orange is V1 Paste, and Blue is Sn63Pb37.
# The oven will warm up. When its ready, press "Enter" to open the tray.
# '''DANGER: The rails could be HOT! Take caution.''' Place the board securely on the rails.
# Press "Enter" to close the tray.
# The preheat will take 2 minutes. The baking process takes about 30 minutes for traces and 3 minutes for the paste..
# The drawer will automatically open to initiate the cool down phase. '''DO NOT remove the board until the oven says all the stages are complete. DANGER: The rails are HOT!'''
# When cool down is complete, remove the board from the oven, and turn off the oven.
Insert text
Insert text
==Safety==
==Safety==
# Always follow the instructions on the LCD Display. It is your guide that keeps you safe.
# Always follow the instructions on the LCD Display. It is your guide that keeps you safe.
# When the Oven Rack opens up after baking a board, be patient and let the board cool down. If you handle it while it is too hot, it can burn you and shift your components (not good).
# When the tray opens up after baking a board, be patient and let the board cool down. If you handle it while it is too hot, it can burn you and shift your components (not good).
# Once you are finished using the Reflow Oven, clean the inside and turn it off. RESET THE SPACE.
# Once you are finished using the Reflow Oven, clean the inside and turn it off. '''RESET THE SPACE'''.
# If you do not want to risk being burnt by the rails when you place your board in the oven, open the tray and place your board '''BEFORE''' selecting a profile.
==Certification==
==Certification==