Changes

Jump to navigation Jump to search
Line 33: Line 33:  
== Training ==
 
== Training ==
 
=== Rolling Steps ===
 
=== Rolling Steps ===
#Adjust the radius by turning the knobs on the front of the machine.
+
#Adjust the radius by turning the knobs on the back of the machine.
#Adjust the tension using the knobs on the back of the machine for materials of different sizes.
+
#Adjust the tension using the knobs on the front left of the machine for materials of different sizes.
 
#Begin by pulling the right side of the top roller out of its slot.
 
#Begin by pulling the right side of the top roller out of its slot.
 
#Insert your piece that you would like to roll between the rollers.
 
#Insert your piece that you would like to roll between the rollers.
 
#Re-secure the top roller inside of the slot prior to rolling.
 
#Re-secure the top roller inside of the slot prior to rolling.
#Crank the crank slowly till you have rolled to the desired radius.
+
#Crank the crank slowly till you have rolled to the desired radius. If the initial radius is not the desired radius, re-roll at a slightly larger radius. Try to limit the number of rolls as to not put too much unnecessary stress on the sheet metal.
 
#Remove the top roller to take your rolled metal out of the roller.
 
#Remove the top roller to take your rolled metal out of the roller.
  
191

edits

Navigation menu