1,341
edits
Changes
Jump to navigation
Jump to search
Line 183:
Line 183: − + − + − + − + − + − + − + − + − + + − +
→Dispensing Tips
###Move the turntable to retrieve your next part.
###Move the turntable to retrieve your next part.
###Repeat steps 1 through 6 until your board is complete.
###Repeat steps 1 through 6 until your board is complete.
##Remove your board from the clamps. Your components
##Remove your board from the clamps. '''Caution: Handle your board with care. Your components are not soldered and can easily dislodge from the paste!'''
##Turn off the Pick<br /> <br />
##Turn off the Pick and Place machine.<br /> <br />
#Back to the oven.
#''Reflow''.
##Power on the oven.
##Power on the oven.
##Select V1 Paste. The warmup period is longer this time.
##Select "V1 Paste." The warm-up period is longer this time.
##Place your board in the oven like how you did the ink '''Rememeber the RAILS ARE HOT.''' Press enter
##Place your board in the oven. '''DANGER: THE RAILS ARE HOT.'''
##Reflow takes about three minutes. When its done, the board will eject. '''Do not touch the board when it is in the cooldown stage.''' The paste is actually soldifying. The oven will tell you when the entire process is complete.
##Select "Enter."
##When complete, remove the board. '''The rails are probably still hot!''' Press enter to close the oven drawer.
##Reflow takes about three minutes. When it's done, the drawer will automatically open to initiate the cool down phase. '''DANGER: The rails are HOT! DO NOT remove the board until the oven says all the stages are complete.''' The solder paste is actually solidifying.
##Turn off the oven <br /> <br />
##When the cool down process is done, remove the board. '''The rails are probably still hot!''' Select "Enter" to close the oven drawer.
#Testing!
##Turn off the oven.<br /> <br />
#''Testing!''
##Take the board over the power supply.
##Take the board over the power supply.
##Ensure to use '''the fixed''' '''5V''' connection on the power supply. Attach the positve and negative leads. Power on the PSU, and press the button. The LED should illuminate!
##Ensure to use '''the fixed''' '''5V''' connection on the power supply. Attach the positive and negative leads. Power on the PSU and press the button. The LED should illuminate!
Congrats! You're done. Got it all? Good. Why don't you go ahead and <u>take the quiz.</u>
Congrats! You're done. Got it all? Good. Why don't you go ahead and <u>take the quiz.</u>