Changes

## Acquire a 1.5" by 2" blank board. They are located in the one of the drawers.

## Acquire a 1.5" by 2" blank board. They are located in the one of the drawers.

## Slide the board underneath the clamps on the Voltera, push the clamps towards each other, and finger-tighten the thumb screws. [[File:Voltera clamping.jpg|border|none|300x300px]] <br />

## Slide the board underneath the clamps on the Voltera, push the clamps towards each other, and finger-tighten the thumb screws. [[File:Voltera clamping.jpg|border|none|300x300px]] <br />

## Click "Next."

## Click "Next." <br /><br />

# ''Mounting the Probe''

# ''Mounting the Probe''

## Pull the probe from one of the drawers. [[File:Voltera drawer.jpg|border|none|300x300px]] <br />

## Pull the probe from one of the drawers. [[File:Voltera drawer.jpg|border|none|300x300px]] <br />

## Remove the cap and place it near the Voltera.

## Remove the cap and place it near the Voltera.

## Mount the probe onto the magnetic gantry. It should snap into place and the contacts should align. [[File:Voltera mount_probe.jpg|border|none|300x300px]] <br />

## Mount the probe onto the magnetic gantry. It should snap into place and the contacts should align. [[File:Voltera mount_probe.jpg|border|none|300x300px]] <br />

## Click "Next."

## Click "Next." <br /><br />

# ''Positioning and Probing''

# ''Positioning and Probing''

## Click "Outline." This will show you where the Voltera thinks the board is. It will move the probe around the printer surface.

## Click "Outline." This will show you where the Voltera thinks the board is. It will move the probe around the printer surface.