1,341
edits
Changes
Jump to navigation
Jump to search
Line 74:
Line 74: − + Line 82:
Line 82: − + − +
→Training
## Reference the [[#Current Inks and Paste|Current Inks and Paste]] for information on the what the PCB lab is currently stocked with.
## Reference the [[#Current Inks and Paste|Current Inks and Paste]] for information on the what the PCB lab is currently stocked with.
## Grab the correct conductive ink from the fridge. It is labeled with a '''green''' sticker.
## Grab the correct conductive ink from the fridge. It is labeled with a '''green''' sticker.
## Set the conductive ink on the table, allowing to begin to warm to room temperature.
## Set the conductive ink on the table, allowing to begin to warm to room temperature. <br />
# ''Software Setup''
# ''Software Setup''
## Download the files for this project [[Media:pcb_printer_level_1.zip|here]].
## Download the files for this project [[Media:pcb_printer_level_1.zip|here]].
## Add the proper conductive ink. This is the same conductive ink you acquired in step 1.3.
## Add the proper conductive ink. This is the same conductive ink you acquired in step 1.3.
## Load the ink file from the project files. This is the Top Layer Gerber file.
## Load the ink file from the project files. This is the Top Layer Gerber file.
## Click "Next."
## Click "Next." <br />
# ''Cleaning the Sensors''
# ''Cleaning the Sensors''
## Take a cue tip and dip it into the isopropyl alcohol. The cue tip should be moist, but NOT soaked. Dab the cue tip on a paper towel to dry it slightly.
## Take a cue tip and dip it into the isopropyl alcohol. The cue tip should be moist, but NOT soaked. Dab the cue tip on a paper towel to dry it slightly.
## Clean the calibration switches by rubbing them with the cue tip. [[File:Voltera cleaning.jpg|border|none|300x300px|Cleaning the calibration switches]] <br />
## Clean the calibration switches by rubbing them with the cue tip. [[File:Voltera cleaning.jpg|border|none|300x300px|Cleaning the calibration switches]] <br />
## Click "Next."
## Click "Next." <br />
# ''Clamping the Substrate''
# ''Clamping the Substrate''
## Acquire a 1.5" by 2" blank board. They are located in the one of the drawers.
## Acquire a 1.5" by 2" blank board. They are located in the one of the drawers.