Changes

* Follow the diagram on the machine housing in order to fill a bobbin. Place the bobbin on the bobbin winder spindle that is on the right top of the machine. Slide the bobbin winder shaft over to the right to lock it.  

* Follow the diagram on the machine housing in order to fill a bobbin. Place the bobbin on the bobbin winder spindle that is on the right top of the machine. Slide the bobbin winder shaft over to the right to lock it.  

* Hold the thread for couple seconds at the beginning as you press the foot pedal gently and slowly. Once it becomes even or uniform, you can let go of the thread and go faster with the foot pedal.

* Hold the thread for couple seconds at the beginning as you press the foot pedal gently and slowly. Once it becomes even or uniform, you can let go of the thread and go faster with the foot pedal.

* Cut the thread once you are done and place the bobbin in the bobbin case. (Before you load the bobbin in the bobbin case, cut off the tail that may be hanging from the hole through which you initially threaded the bobbin.) The drop in bobbin is covered by a plastic cover that you can remove by gently pulling the hook cover release button. Load the bobbin by following the diagram on the plastic cover. Replace the cover.

* Cut the thread once you are done and place the bobbin in the bobbin case. (Before you load the bobbin in the bobbin case, cut off the tail that may be hanging from the hole through which you initially threaded the bobbin.) The drop-in bobbin is covered by a plastic cover that you can remove by gently pulling the hook cover release button. Load the bobbin by following the diagram on the plastic cover. Replace the cover.

<u>Threading the machine</u>

<u>Threading the machine</u>

* Draw thread from the thread spool and thread the machine by following the directional numbered arrows on the housing of the machine. Make sure the thread is well-seated between the tension discs at the numbered dial and is through the eye of the take-up lever--part 7 in the manual. At the end, thread the needle.

* Draw thread from the thread spool and thread the machine by following the directional numbered arrows on the housing of the machine. Make sure the thread is well-seated between the tension discs at the numbered dial and is through the eye of the take-up lever--part 7 in the manual. At the end, thread the needle.