83
edits
Changes
Jump to navigation
Jump to search
Line 89:
Line 89: − + − + − + − +
→Operation
<u>Winding the bobbin</u>
<u>Winding the bobbin</u>
* Once you picked the type/color of thread spool, first get some of it loose and out and secondly place it on the large spool holder (skinny tub). Then, add the spool cap. It's side will depend on the type/ style of thread spool you picked.
* Choose your thread. Make sure you find the end before you put the spool of thread on the spool pin. Use a spool cap to hold it in place. Make sure there is no gap between the cap and the spool of thread. The thread being drawn from the spool when sewing can become tangled in any gap and break.
* As you follow the guide images, put the thread around the metal knob (upper thread guide). Then slide the thread through one of the holes in the bobbin and place it in the bobbin winder spindle (small metal tube) that its on the right top of the machine. Slide the bobbin winder shaft over to lock it.
* Follow the diagram on the machine housing in order to fill a bobbin. Place the bobbin on the bobbin winder spindle that is on the right top of the machine. Slide the bobbin winder shaft over to the right to lock it.
* Hold the thread for couple seconds at the beginning as you press the foot pedal gently and slowly. Once it becomes even or uniform, you can let go of the thread and go faster with the foot pedal.
* Hold the thread for couple seconds at the beginning as you press the foot pedal gently and slowly. Once it becomes even or uniform, you can let go of the thread and go faster with the foot pedal.
* Cut the thread once you are done and place the bobbin in the bobbin case. The drop in bobbin is covered by a plastic cover that you can remove by gently pulling the hook cover release button. Drop the bobbin and wrap the thread around a the clip under the plastic cover. Then, put the cover on.
* Cut the thread once you are done and place the bobbin in the bobbin case. (Before you load the bobbin in the bobbin case, cut off the tail that may be hanging from the hole through which you initially threaded the bobbin.) The drop in bobbin is covered by a plastic cover that you can remove by gently pulling the hook cover release button. Load the bobbin by following the diagram on the plastic cover. Replace the cover.
<u>Threading the machine</u>
<u>Threading the machine</u>
* Grab onto the thread from the thread spool and run the thread through the knob and going down then up, following the image guide around and make sure it is catching all parts. At the end thread the needle.
* Draw thread from the thread spool and thread the machine by following the directional numbered arrows on the housing of the machine. Make sure the thread is well-seated between the tension discs at the numbered dial and is through the eye of the take-up lever--part 7 in the manual. At the end, thread the needle.
====Demonstration====
====Demonstration====