1,947
edits
Changes
Jump to navigation
Jump to search
Line 52:
Line 52: − + + +
→Overview
====Overview====
====Overview====
The disc sander allows you to sand outside corners and flat surfaces using an abrasive disc. The belt can perform inside corner and flat surface sanding. The table angles can be adjusted to change the angle of cuts. The sanding table can be set between 15 and 45 degrees. The belt arm can be adjusted between 0 and 90 degrees with the arm locking handle. It is important to inspect the sanding disc and belt for wear before use. If you notice any holes or cuts in a belt let the supervisor know before trying to power the machine. Tears can be caused by leaving material in the same spot too long. Try to keep work moving across the belt/disc to prevent damage. The disc normally won't tear but it will turn dark and have burn marks.
The vacuum former can mold up to a 19"x17" square and to a depth of 7.3".
Molds must slant outwardly slightly to ensure that they can be popped out of the plastic after molding is finished.
====Demonstration====
====Demonstration====