Changes

# Turn on the machine using the power switch located on the back of the machine in the left corner. The machine will go through a startup procedure where the cutting bed lowers and the laser travels to its home position. Note that the lid must be closed for the startup procedure to begin and there will be some beeping coming from the machine which is normal.   

# Turn on the machine using the power switch located on the back of the machine in the left corner. The machine will go through a startup procedure where the cutting bed lowers and the laser travels to its home position. Note that the lid must be closed for the startup procedure to begin and there will be some beeping coming from the machine which is normal.   

# Place your material onto the honeycomb table, preferably in the upper left corner.   

# Place your material onto the honeycomb table, preferably in the upper left corner.   

# Now it’s time to focus the laser onto your material. Begin by moving the laser head over the middle of your material; then place the focusing tool on the laser head and slowly raise the table until the the focusing tool falls off. Raise the bed extra slow when raching the focusing tool so the bed can be stopped the moment the tool falls off. Reference the images below for proper focusing tool placement and laser head controls. [[File:Laser Focus Tool.png|none|thumb|404x404px| Proper placement of the focusing tool. ]][[File:Laser Controls.png|none|thumb]]

# Now it’s time to focus the laser onto your material. Begin by moving the laser head over the middle of your material; then place the focusing tool on the laser head and slowly raise the table until the the focusing tool falls off. Raise the bed extra slow when raching the focusing tool so the bed can be stopped the moment the tool falls off. Reference the images below for proper focusing tool placement and laser head controls. [[File:Laser Focus Tool.png|none|thumb|404x404px| Proper placement of the focusing tool. ]][[File:Laser Controls.png|none|thumb|296x296px| Laser control pad. (1) Raise and lower the bed. (2) Move the laser head (5) Air assist. Make sure it is always on to vent fumes properly.  ]]

#  

#  

Cutting with Job Control :

Cutting with Job Control :