1,341
edits
Changes
Jump to navigation
Jump to search
Line 138:
Line 138: + Line 145:
Line 146: − + + + + + + + + + + +
→Level 1
##Replace the barnishing pad back into the drawer
##Replace the barnishing pad back into the drawer
#Clever title for this section
#Clever title for this section
##At this time, retreive the solder paste from the fridge and set it out to warm
##Take the board back to the Voltera
##Take the board back to the Voltera
##Clamp the board into place.
##Clamp the board into place.
##'''Like before, clean the calibration switches'''
##'''Like before, clean the calibration switches'''
##Mount the probe, next
##Mount the probe, next
##Click move to feature. This will the probe to a pre selected feature. It will not be aligned properly.
##First, use the arrow keys to roughly align the feature with the probe.
##Next, click Lower, and use the arrow keys to fine-tune the alignment. Your precision in these steps is key to getting solder paste in the correct places.
##Click Measure when the alignment is correct. The head will then move to a second feature.
##Repeat steps 9 and 10.
##Click Measure. The alignment is now finished. Click Next
##You can confirm alignment by clicking various parts and seeing if they are correct. If something is off, you can go back and realign if neccessary.
##Click Next.
##Click probe. This will measure the height of the board.
##Remove the probe and replace it inthe drawer.
##
<br /><br />
<br /><br />