Line 132: |
Line 132: |
| ## '''DANGER: The rails could be HOT! Take caution.''' Place the board securely on the rails. [[File:bake_place.jpg|300x300px|none]] <br /> | | ## '''DANGER: The rails could be HOT! Take caution.''' Place the board securely on the rails. [[File:bake_place.jpg|300x300px|none]] <br /> |
| ## Press "Enter" to close the tray. [[File:bake_go.jpg|300x300px|none]] <br /> | | ## Press "Enter" to close the tray. [[File:bake_go.jpg|300x300px|none]] <br /> |
− | ## The preheat will take 2 minutes. The baking process takes about 30 min. [[File:bake_inside.jpg|300x300px|none]] | + | ## The preheat will take 2 minutes. The baking process takes about 30 min. [[File:bake_inside.jpg|300x300px|none]] talk about taking it out of the oven |
| + | #''Preparing for Solder Paste'' |
| + | ##Take a barnishing pad from one of the drawers. |
| + | ##Rub the substrate until the traces have a shine to them, rather than a dull apprentice. |
| + | ##Replace the barnishing pad back into the drawer |
| + | #Clever title for this section |
| + | ##Take the board back to the Voltera |
| + | ##Clamp the board into place. |
| + | ##Open the volteraapp and choose "Solder" |
| + | ##Choose the proper paste, in this case you want the orange labeled paste |
| + | ##'''Edit the gerber so that theres no solder paste on pads''' |
| + | ##'''Like before, clean the calibration switches''' |
| + | ##Mount the probe, next |
| | | |
| <br /><br /> | | <br /><br /> |
| | | |
− | === Level 2 === | + | === Lev === |
| + | === el 2 === |
| CHANGE this: <s>After completing the Hello World tutorial, you can proceed with making double-sided boards. Voltera has a tutorial called "Punk Console" which walks through creating your own double-sided board. It also shows how to use the V-One drill to make vias and component through-holes.</s> [[File:voltera_nick.jpg|300x300px|thumb|right|Wow]] | | CHANGE this: <s>After completing the Hello World tutorial, you can proceed with making double-sided boards. Voltera has a tutorial called "Punk Console" which walks through creating your own double-sided board. It also shows how to use the V-One drill to make vias and component through-holes.</s> [[File:voltera_nick.jpg|300x300px|thumb|right|Wow]] |
| * [https://support.voltera.io/hc/en-us/sections/115001111653-Start-Drilling <s>Punk Console Tutorial</s>] | | * [https://support.voltera.io/hc/en-us/sections/115001111653-Start-Drilling <s>Punk Console Tutorial</s>] |