1,947
edits
Changes
Jump to navigation
Jump to search
Line 73:
Line 73: − + − + − + + + + + + + + +
→General Procedure
# Molding
# Molding
## Turn on the power switch.
## Turn on the power switch.
## Make sure the SV value is correct on the temp controller for the type of material you are using.
## Make sure the SV value is correct on the temp controller for the type of material you are using. Adjust the temp controller using the setting buttons if the SV value needs adjusting.
## Now we can starting molding materials!
## Wait for the PV value to reach the SV value.
## First we need to set the temperature for the mold.
## Now add pellets to the feeder.
## Wait several minutes for the pellets to melt. If you want to preheat the mold now is the time.
## You should see a small amount of plastic ooze from the nozzle
## Make sure the mold is clamped tight and the nozzle nipple is aligned with the mold sprue.
## Scrape away any oozing plastic from the nozzle using a screwdriver or similar tool.
## With a smooth linear motion push down on the handle and fill the mold.
## Hold pressure on the handle for an extra few seconds.
## Retract the handle all of the way to remove the plunger and give access to load more pellets.
## You can now remove the mold and separate the halves.
==Safety==
==Safety==