473
edits
Changes
Jump to navigation
Jump to search
Line 80:
Line 80: − + + + + + Line 87:
Line 91: − + + − Insert text+ + − + − + − + + + + + + +
no edit summary
# Reset the space when finished by vacuuming any dusk, returning the router to its box and putting away any scrap material.
# Reset the space when finished by vacuuming any dusk, returning the router to its box and putting away any scrap material.
==Safety==
==Safety==
*
* Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury or damage the machine.
* Always use the dust collection system to keep the dust levels in the wood shop from reaching a dangerous level.
* Always hold onto the router while it is cutting. It is a CNC but it is not fastened to anything and could tip over if the bit catches on the material.
* Cut at an appropriate feed rate. If Origin’s correction range is unable to keep up with your feed rate, move Origin slower, reduce the depth of cut, change your router bit, and/or adjust the spindle speed.
* Adhere work piece elements that may come loose during cutting. When cutting items out of work piece materials, use double sided tape or alternative methods to hold elements down to your workbench and/or spoil board. This will prevent items from coming loose when cutting is complete.
==Certification==
==Certification==
==Troubleshooting==
==Troubleshooting==
*
* Cut is to big or small. The router will cut exactly on the cut line which often results in tight fitting parts. Use the offset option in the cut settings to increase or decrease the cut size by a minimal amount.
* The router keeps losing track of the Shaper Tape during a cut. Try rotating the router during the cut so the camera is always pointing towards the tape. If the problem persists add more tape.
==Maintenance==
==Maintenance==
====General maintenance====
====General maintenance====
To keep this machine working properly, wipe off any dust that was collected on it while cutting before putting it away. There is also a chip tray on the front of the router that needs to be cleaned out as it fill up.
====Specific Maintenance Tasks====
====Specific Maintenance Tasks====
{| class="wikitable"
{| class="wikitable"
!
!Maintenance Procedure
!Maintenance Procedure
!Frequency
!Frequency
!Done By
!Done By
|-
|-
|Sample
|1
|Sample
|Wipe down the Router
|Sample
|After each use
|Student
|-
|2
|Clean the chip tray
|When it is close to full
|Student
|}
|}