1,956
edits
Changes
Jump to navigation
Jump to search
Line 57:
Line 57: − [[File:TABLE_SAW_CONTROLS.jpg|none|thumb|600x600px]] Line 66:
Line 65: −
→General Procedure
====General Procedure====
====General Procedure====
#Adjust the radius by turning the knobs on the back of the machine. This adjusts the distance between the rollers.
#Adjust the radius by turning the knobs on the back of the machine. This adjusts the distance between the rollers.
#Slowly rotate the handle until you have rolled to the desired radius. If the initial radius is not the desired radius, re-roll at a slightly tighter radius.
#Slowly rotate the handle until you have rolled to the desired radius. If the initial radius is not the desired radius, re-roll at a slightly tighter radius.
#Unlock the top roller to slide your rolled metal off the end of roller.
#Unlock the top roller to slide your rolled metal off the end of roller.
==Safety==
==Safety==