Changes

# To open the Toolpaths menu click the Toolpaths tab on the top right of your screen. Once the menu appears, turn off auto hide by clicking on the push pin icon.

# To open the Toolpaths menu click the Toolpaths tab on the top right of your screen. Once the menu appears, turn off auto hide by clicking on the push pin icon.

# Before defining any Toolpaths it is a good idea to open the material setup menu and double check that everything is set up correctly.  

# Before defining any Toolpaths it is a good idea to open the material setup menu and double check that everything is set up correctly.  

## Thickness: it is obviously important that the thickness of your material is accurate to avoid cutting deep into the spoil-board or not all the way through your part.

## Thickness: It is obviously important that the thickness of your material is accurate to avoid cutting deep into the spoil-board or not all the way through your part.

## XY Datum: Ensure that you understand where the datum is so you can accurately position your part inside your wood stock.

## XY Datum: Ensure that you understand where the datum is so you can accurately position your part inside your lumber.

## Z -Zero MUST be set to Machine Bed. (This has been mentioned many times because it is very important).

## Z -Zero MUST be set to Machine Bed. (This has been mentioned many times because it is very important).

## Model Position in Material: This is for 3D carving and is used to tell the computer where you want to *gasp* position the model in the material.

## Model Position in Material: This is for 3D carving and is used to tell the computer where you want to *gasp* position the model in the material.