1,956
edits
Changes
Jump to navigation
Jump to search
Line 53:
Line 53: − + − + − + + + + Line 65:
Line 68: − −
→Demonstration
Demonstrate you can safely setup the saw and rip a board. You will then proceed to cross cut one of the remaining piece.
Demonstrate you can safely setup the saw and rip a board. You will then proceed to cross cut one of the remaining piece.
1. Ensure that the material you are cutting has at least one straight edge and no nails or foreign objects. The straight edge will slide against the fence when ripping.<b/r>
1. Ensure that the material you are cutting has at least one straight edge and no nails or foreign objects. The straight edge will slide against the fence when ripping.<b/r>
2. Measure the width of the board and determine the width of cut.
3. Lift the locking handle on the fence and slide the fence to set the width using the scale. Make sure you use the scale for the correct side of the blade.
2. Measure the width of the board and determine the width of cut.
3. Lift the locking handle on the fence and slide the fence to set the width using the scale. Make sure you use the scale for the correct side of the blade.
4. Lock the fence by pressing down on the locking handle.
4. Lock the fence by pressing down on the locking handle.
5. Use the blade lift handle on the front of the saw to set the height of the blade approximately 1 tooth above the height of the material. Use the material as a gauge.
5. Use the blade lift handle on the front of the saw to set the height of the blade approximately 1 tooth above the height of the material. Use the material as a gauge.
11. It is helpful to have someone assisting on the back side of the saw to help hold material being fed off the table.
11. It is helpful to have someone assisting on the back side of the saw to help hold material being fed off the table.
12. When you are done with the saw cut press in on the paddle switch to turn off the saw.
12. When you are done with the saw cut press in on the paddle switch to turn off the saw.