Line 138: |
Line 138: |
| ##Replace the barnishing pad back into the drawer | | ##Replace the barnishing pad back into the drawer |
| #Clever title for this section | | #Clever title for this section |
| + | ##At this time, retreive the solder paste from the fridge and set it out to warm |
| ##Take the board back to the Voltera | | ##Take the board back to the Voltera |
| ##Clamp the board into place. | | ##Clamp the board into place. |
Line 145: |
Line 146: |
| ##'''Like before, clean the calibration switches''' | | ##'''Like before, clean the calibration switches''' |
| ##Mount the probe, next | | ##Mount the probe, next |
− | | + | ##Click move to feature. This will the probe to a pre selected feature. It will not be aligned properly. |
| + | ##First, use the arrow keys to roughly align the feature with the probe. |
| + | ##Next, click Lower, and use the arrow keys to fine-tune the alignment. Your precision in these steps is key to getting solder paste in the correct places. |
| + | ##Click Measure when the alignment is correct. The head will then move to a second feature. |
| + | ##Repeat steps 9 and 10. |
| + | ##Click Measure. The alignment is now finished. Click Next |
| + | ##You can confirm alignment by clicking various parts and seeing if they are correct. If something is off, you can go back and realign if neccessary. |
| + | ##Click Next. |
| + | ##Click probe. This will measure the height of the board. |
| + | ##Remove the probe and replace it inthe drawer. |
| + | ## |
| <br /><br /> | | <br /><br /> |
| | | |