124
edits
Changes
Jump to navigation
Jump to search
Line 130:
Line 130: + + +
no edit summary
==Troubleshooting==
==Troubleshooting==
====ProtoMAX Layout====
====Water Jet Cutter====
There are a few common issues you may run into when using the waterjet. First, there may be an issue reaching the proper water level for your material. This is caused by the drain tube on the right side of the tank being at the incorrect height and can be fixed by pushing the drain tube up or down to remove water or allow more to enter. Make sure to wear gloves when doing this to protect from bacteria and never pull on the tube because it can be pulled off. If the tube does pull off don't panic; wait for the water to drain low enough to push the tube back on and then do so.
There are a few common issues you may run into when using the waterjet. First, there may be an issue reaching the proper water level for your material. This is caused by the drain tube on the right side of the tank being at the incorrect height and can be fixed by pushing the drain tube up or down to remove water or allow more to enter. Make sure to wear gloves when doing this to protect from bacteria and never pull on the tube because it can be pulled off. If the tube does pull off don't panic; wait for the water to drain low enough to push the tube back on and then do so.