Mood Lamp

In this TV, we will create a mood lamp. The lamp consists of an internal ...

Create the wooden "heels" and "slices"

I thought about calling this project the "light loaf" due to the terminology of heels and slices. The heels are the pieces that go on each end of the mood lamp. These are 5.5" square. The slices are made up of 4 mitered 1/2"x5.5" pieces glued together. You will need to create 2 heels and 3 slices. Additionally, you will need to create a base "slice" that will house the controls. This is made up of 4 mitered 2"x5.5" pieces.

Plane the board

You will begin with a 4'x8" board. As everything in the project is based on 1/2" pieces, you will need to initially plane the entire board down to 1/2" thickness

Cut the board

When planning on how to cut your board, you will want to make sure that the grain of the wood runs horizontally along the slices, allowing for maximum strength. One possible way to lay out your wood is given in the picture below. Always remember that you must allow for the kerf of the saw blade. On the table saw, this is generally 1/8".

For this scenario, you might want to do the following:

• Cut a 12" piece off of one end of the board. Rip this to 5.5", then cut 2 5.5" pieces from the remnant.
• Rip a 2" piece off of the length of the board.
• Rip 2 (or 3) 1/2" pieces off of the length of the board.
• Take these pieces that have been ripped, and then cut them into 5.5" strips.
• Miter each of these pieces.

Assemble the slices

• Assemble the 1/2" strips into 3 squares. Glue them up and clamp them in the Angle Strap Clamps.

Introduce yourself to Solidworks

Go to the Solidworks Training page and complete the recommended tutorials. This could take a couple of hours.

Assemble the base slice

Before assembling the base slice, we will need to cut holes for the controls, as well as an inset so that we can inlay aluminum control plates. Two of the base sides will be unaffected, but two will have the same hole/inset pattern. When the holes and inlays have been cut, the base can be glued and clamped just as the slices were above.

Program the Arduino

Program the Arduino to read in the A/D values

Verify using the printouts

Assemble the electronics

Solder the solid-core connecting wires

=== Solder the

== Create the