Difference between revisions of "Scroll Saw"
(→Safety) |
(→Safety) |
||
Line 79: | Line 79: | ||
* Use a brush to clear away chips and sawdust. | * Use a brush to clear away chips and sawdust. | ||
* Allow the blade to do the cutting at its own speed. Don't force material into the blade. | * Allow the blade to do the cutting at its own speed. Don't force material into the blade. | ||
− | * Make sure the material hold down is correctly adjusted. | + | * Make sure the material hold down is correctly adjusted. The hold down should never impede the material movement and should barely sit above the material. |
==Certification== | ==Certification== |
Revision as of 15:36, 18 October 2019
The Excalibur EX-21 Scroll Saw is a small variable speed electric saw. It operates similarly to a band saw, but uses a reciprocating blade instead of a loop. This reciprocation means the blade does not cut continuously and only on the down stroke. The thinness of the blade allows it to be turned in the work piece at an almost 90 degree angle, which allows the blade to track along fine detail and sharp lines. The blade can also be removed on either the top or bottom of the reciprocating arm which allows the blade to be inserted inside of a work piece without needing an entry cut, the only thing necessary is a small hole drilled through the material. There is a blade guard and a dust blower nozzle that both need to be adjust before a piece can be cut into the material.
The current Ace of the Scroll Saw is Needed (Makerhub@georgefox.edu).
Documentation
Training
Tips
When cutting a pattern, overlay the pattern on the workpiece, then work the piece smoothly through the blade path. By maintaining a constant forward movement and turning the piece as to keep the pattern line directly in front of the blade teeth, a smooth and accurate pattern can be cut. If the workpiece ever stops moving forward through the blade, the cut pattern will not be perfectly smooth.
The scroll saw can cut extremely tight curves, by backing up the blade a hair the scroll saw can even cut what is almost a re-entrant corner. This is only advisable in soft woods, and can leave burn marks on the wood.
Make: Excalibur
Model: EX-21
Ace: Needed (Makerhub@georgefox.edu).
Location: Wood Shop
Description
Insert Description Text
Here is an example of this piece of equipment being used.
Insert video media here.
Documentation
Terminology
Insert terminology here
User Manual
Training
Overview
Insert Text
Demonstration
Insert text
General Procedure
Insert text
Safety
There are several hazards you need to be aware of when using a scroll saw.
- Keep your fingers and hands away from the blade and all moving parts.
- Always wear proper safety equipment to prevent injury.
- Hold onto material firmly as the blade will try to lift the material off the table.
- Use a brush to clear away chips and sawdust.
- Allow the blade to do the cutting at its own speed. Don't force material into the blade.
- Make sure the material hold down is correctly adjusted. The hold down should never impede the material movement and should barely sit above the material.
Certification
Troubleshooting
Maintenance
General maintenance
Insert text
Specific Maintenance Tasks
Maintenance Procedure | Frequency | Done By |
---|---|---|
Sample | Sample | Sample |