Changes

Jump to navigation Jump to search
1,029 bytes added ,  3 years ago
Line 79: Line 79:     
[[Image:Quena_12.png|400px]]
 
[[Image:Quena_12.png|400px]]
 +
 +
Step 13: Next, create a new sketch on that pink face. on this face, draw 2 lines vertically down from the sides of the notch, and then connect them with 2 arcs. The arc tool is circled in red in the upper left corner.
 +
Dimension the arcs as shown.
 +
 +
[[Image:Quena_13.png|400px]]
 +
 +
Step 14: Next, use the trim tool from earlier to reduce the sketch down to a single loop.
 +
For the upper parts of the 2 vertical lines, trim them to construction geometry. This preserves the relation between the lines and the notch.
 +
For the lower part of the lines, uncheck the "keep trimmed entities as construction geometry" box, and it will delete the overhanging part of the line.
 +
 +
[[Image:Quena_14.png|400px]]
 +
 +
Step 15: Now, extrude cut with this sketch. the cut should go all the way through
 +
 +
[[Image:Quena_15.png|400px]]
 +
 +
And you're done!
 +
 +
 +
==3D printing===
 +
 +
For instructions on using the 3D printers, see the prussa page HERE
 +
 +
The part prints best if printed upright, and with supports under the overhang.
 +
 +
[[Image:Quena_16.png|500px]]
232

edits

Navigation menu