Changes

### Tilt table to desired angle.  

### Tilt table to desired angle.  

### Re-tighten bolt and set screw, and ensure table is securely locked in place before drilling.

### Re-tighten bolt and set screw, and ensure table is securely locked in place before drilling.

## For blind holes, lock the table at desired depth:

## For blind holes, use the depth stop to stop the drill bit at the desired depth.

### To lock the quill at a certain depth, pull the quill lever down to the desired level and turn the quill lock handle clockwise and tighten firmly.

### Adjust the depth stop by rotating it until it is at the desired height.

### If the quill lock handle is not fully tightened when it reaches its limit:

#### For large adjustments, pressing the button on the depth stop enables it to move up and down freely. 

#### Pull the handle out along the screw so it freely rotates ['''Note: clarify where the "screw" is and what its function is.]'''

### The lever to the right of the spindle may be used to lock the drill bit at a desired depth while you adjust the depth stop. (i.e. lock the drill bit at the depth you want, then move the depth stop to the corresponding position.)

#### Rotate back counter-clockwise

#### Remember to unlock the lever prior to drilling. 

# Line piece up with drill bit and fasten down onto work table using a clamp or vice. If drilling a through hole, put a piece of FLAT scrap wood under the piece being drilled to avoid a blowout.  

# Line piece up with drill bit and fasten down onto work table using a clamp or vice. If drilling a through hole, put a piece of FLAT scrap wood under the piece being drilled to avoid a blowout.  

# Turn power on using switch located on the right side of the machine as shown in the picture below. The yellow tab must be in place for the drill to be powered on.[[File:...voyagerthing.png|none|thumb]]

# Turn power on using switch located on the right side of the machine as shown in the picture below. The yellow tab must be in place for the drill to be powered on.[[File:...voyagerthing.png|none|thumb]]

* [https://www.teknatool.com/product/nova-voyager-dvr-variable-speed-drill-press-exclusive-amazon-bundle/?gclid=EAIaIQobChMI4PzDxsni2wIVFNNkCh3lBAcLEAAYASAAEgL5NvD_BwE Product Home Page]

* [https://www.teknatool.com/product/nova-voyager-dvr-variable-speed-drill-press-exclusive-amazon-bundle/?gclid=EAIaIQobChMI4PzDxsni2wIVFNNkCh3lBAcLEAAYASAAEgL5NvD_BwE Product Home Page]

* <figure-inline class="mw-default-size">[[File:wood_drill_press_operation_manual|220x220px]]

* <figure-inline class="mw-default-size"><figure-inline>[[File:wood_drill_press_operation_manual|220x220px]]</figure-inline>

* [https://www.youtube.com/watch?v=6PvDExhAOC8 First look]

* [https://www.youtube.com/watch?v=6PvDExhAOC8 First look]

== Training ==

== Training ==

* <figure-inline class="mw-default-size">[[File:wood_drill_press_operation_manual|220x220px]]

* <figure-inline class="mw-default-size"><figure-inline>[[File:wood_drill_press_operation_manual|220x220px]]</figure-inline>

<br /><br /><br /><br /><br />

<br /><br /><br /><br /><br />