Difference between revisions of "Belt/Disc Sander"
Jump to navigation
Jump to search
| Line 71: | Line 71: | ||
====General maintenance==== | ====General maintenance==== | ||
| − | + | The following items need to be periodically lubricated: | |
| + | * Idler slide (use non hardening grease) | ||
| + | *Table trunnion (use non hardening grease) | ||
====Specific Maintenance Tasks==== | ====Specific Maintenance Tasks==== | ||
Revision as of 16:00, 21 October 2019
Make: PowerMatic
Model: BD31A
Ace: Needed (Makerhub@georgefox.edu).
Location: Wood Shop
Description
The belt/disc sander allows you to quickly remove material.
Here is an example of this piece of equipment being used.
Insert video media here.
Documentation
Terminology
Insert terminology here
Training
Overview
Insert Text
Demonstration
You will need to demonstrate the safe setup and use of the belt/disc sander.
General Procedure
Insert text
Safety
- Sanding creates heat due to the friction. Be careful not to burn your fingers.
- Never put your hand in a position that slipping could cause you to make contact with the belt or disc.
- Never reach over the machine.
- Use a brush when clearing sawdust from the tables, not your hands.
- Use light pressure when removing material. Never try to force feed the machine.
- Avoid kickbacks by sanding on the correct side of the disc. Do not sand on the right hand portion of the disc.
Certification
Troubleshooting
Maintenance
General maintenance
The following items need to be periodically lubricated:
- Idler slide (use non hardening grease)
- Table trunnion (use non hardening grease)
Specific Maintenance Tasks
| Maintenance Procedure | Frequency | Done By |
|---|---|---|
| Replace sanding Belt/Pad | As Needed | Ace/Tech |