Changes

* Trigger - The lever- esc thing on top of the handle responsible for bracing the forming nose against bending in a particular direction. The trigger should always point in the direction that the handle is being pulled.  

* Trigger - The lever- esc thing on top of the handle responsible for bracing the forming nose against bending in a particular direction. The trigger should always point in the direction that the handle is being pulled.  

* Adjusting Bolt - NOT a technical term, used instead of "SCREW-HHCS 1/2-20X2". For the purposes of explaining how to use the hand bender, the adjusting bolt refers to the bolt that you loosen to adjust the distance between the forming nose is to the radius pin. See #27 on the figure on page 4 of the [https://maker-hub.georgefox.edu/w/images/0/04/Di-Acro_Hand_Bender.pdf User Manual]  

* Adjusting Bolt - NOT a technical term, used instead of "SCREW-HHCS 1/2-20X2". For the purposes of explaining how to use the hand bender, the adjusting bolt refers to the bolt that you loosen to adjust the distance between the forming nose is to the radius pin. See #27 on the figure on page 4 of the [https://maker-hub.georgefox.edu/w/images/0/04/Di-Acro_Hand_Bender.pdf User Manual]  

[[:File:Di-Acro Hand Bender.pdf|User Manual]]

 

[[Media:Di-Acro Hand Bender.pdf|Hand Bender User Manual]]

[https://www.diacro.com/wp-content/uploads/2016/07/Art-Of-Bending_2013.pdf Art of Bending]

[https://www.diacro.com/wp-content/uploads/2016/07/Art-Of-Bending_2013.pdf Art of Bending]