1,956
edits
Changes
Jump to navigation
Jump to search
Line 50:
Line 50: + +
→2. Reset the Space
There are smaller blue tables that also have spots marked on the floor for their permanent homes. These tables reside on the wall nearest the quad. These tables can be used as transport tables for your projects. There are some limited storage locations in the Hub, and you can use these tables to transport your projects from these locations to wherever you might need in the Hub. When you are finished using these tables, please clear them off and put them back. If, for some special reason, you need the table to be in use for a short time (less than three days), mark the table as in use. This is useful if you want to run overnight tests or you are in the middle of an assembly. However, this is for short term use.
There are smaller blue tables that also have spots marked on the floor for their permanent homes. These tables reside on the wall nearest the quad. These tables can be used as transport tables for your projects. There are some limited storage locations in the Hub, and you can use these tables to transport your projects from these locations to wherever you might need in the Hub. When you are finished using these tables, please clear them off and put them back. If, for some special reason, you need the table to be in use for a short time (less than three days), mark the table as in use. This is useful if you want to run overnight tests or you are in the middle of an assembly. However, this is for short term use.
When using the electronics station, it is, as always, imperative that you RESET THE SPACE. Clean up all solder paste, stripped wires, etc., and put everything back where you found it, putting the cables back where they go.
On the wall are a set of tools. These are available for use within the Maker Hub. As should be obvious, when you are done using the tools, return them - RESET THE SPACE. For example, if you use a tool put it back when you are done. Not much of an example. Sort of hard to make this any more clear. Let’s say it is a wrench - and you use it. When you are done - put it back. Get it? The tools are marked with blue paint to indicate they belong in the Maker Hub.
On the wall are a set of tools. These are available for use within the Maker Hub. As should be obvious, when you are done using the tools, return them - RESET THE SPACE. For example, if you use a tool put it back when you are done. Not much of an example. Sort of hard to make this any more clear. Let’s say it is a wrench - and you use it. When you are done - put it back. Get it? The tools are marked with blue paint to indicate they belong in the Maker Hub.
If you are a senior and you need tools for your project and don’t want to return them, check them out from the toolroom. If we don’t have them, speak with your advisor and we can see about getting them. In the meantime, put them back. If you are an employee and need equipment and/or tools in your place of employment, do not abscond with the tools on the wall. You may certainly use them, but you must put them back. If you want tools permanently in your shop, ask the technician and the problem can be remedied.
If you are a senior and you need tools for your project and don’t want to return them, check them out from the toolroom. If we don’t have them, speak with your advisor and we can see about getting them. In the meantime, put them back. If you are an employee and need equipment and/or tools in your place of employment, do not abscond with the tools on the wall. You may certainly use them, but you must put them back. If you want tools permanently in your shop, ask the technician and the problem can be remedied.