1,947
edits
Changes
Jump to navigation
Jump to search
Line 66:
Line 66: − +
→Demonstration
====Demonstration====
====Demonstration====
Demonstrate you can safely setup the saw and rip a board. You will then proceed to cross cut one of the remaining pieces. Remember to set the blade height so it is protruding less than 1/4" out the top of material for less exposure. When performing a rip cut the fence is used to guide the lumber into the blade. You want to make sure that the distance between the fence and blade is the width of desired cut. Mark the edge of the material when doing a cross cut so you can align the material with the blade in the sled. You can also use a miter gauge for making cross cuts but make sure the material is long enough and well supported.
Demonstrate you can safely setup the serger. You will then proceed to edge a piece of scrap material.
====General Procedure====
====General Procedure====