Changes

Jump to navigation Jump to search
Line 55: Line 55:  
====Demonstration====
 
====Demonstration====
   −
Insert text
+
To demonstrate competency on the Bending brake you will be required to bend a sheet metal to a 90 degree angle.
    
====General Procedure====
 
====General Procedure====
Line 65: Line 65:  
#Insert your work piece to the line you want to bend, centered in the brake, and clamp your piece securely.
 
#Insert your work piece to the line you want to bend, centered in the brake, and clamp your piece securely.
 
#Pull up on the bending handle of the leaf slowly until your piece is bent to the desired angle, and slowly lower the leaf.
 
#Pull up on the bending handle of the leaf slowly until your piece is bent to the desired angle, and slowly lower the leaf.
#If the piece does not bend straight, unclamp the handle on the overbent side and adjust the top leaf.
+
#If the piece does not bend straight, unclamp the handle on the over-bent side and adjust the top leaf.
 
#Adjust the clamp handle, and remove your piece.
 
#Adjust the clamp handle, and remove your piece.
 
#Put back any fingers if adjusted, and deburr if any rough edges are left.
 
#Put back any fingers if adjusted, and deburr if any rough edges are left.
411

edits

Navigation menu