Changes

Jump to navigation Jump to search
Line 62: Line 62:     
Edge Cleanup
 
Edge Cleanup
 +
Do not perform jointing operations on material shorter than
    
1. Ensure that the material you are cutting is free from nails and foreign objects. Foreign material will damage the cutters and create flying hazards. Check for problematic knots too.
 
1. Ensure that the material you are cutting is free from nails and foreign objects. Foreign material will damage the cutters and create flying hazards. Check for problematic knots too.
   −
2. Make sure the board is at least 10" long and at least 3/8" wide to prevent the board from tilting while cutting. Do not joint workpieces less than 1/4" thick.
+
2. Make sure the board is at least 8" long and at least 3/4" wide to prevent the board from tilting while cutting. Do not joint workpieces less than 1/4" thick.
    
3. Check the cut gauge on the front table. Make sure you know how much material is being removed. Never adjust the rear table.  
 
3. Check the cut gauge on the front table. Make sure you know how much material is being removed. Never adjust the rear table.  
Line 89: Line 90:  
1. Ensure that the material you are cutting is free from nails or foreign objects. Foreign material will damage the cutters and create flying hazards. Check for problematic knots too.
 
1. Ensure that the material you are cutting is free from nails or foreign objects. Foreign material will damage the cutters and create flying hazards. Check for problematic knots too.
   −
2. Make sure the board is at least 10" long x 2" wide to prevent the board from tilting while facing. Do not joint workpieces less than 1/4" thick.
+
2. Make sure the board is at least 8" long x 2" wide to prevent the board from tilting while facing. Do not joint workpieces less than 1/4" thick.
    
3. Check the cut gauge. When facing you normally want to take off a small amount of material per pass due to the large surface area.  
 
3. Check the cut gauge. When facing you normally want to take off a small amount of material per pass due to the large surface area.  
1,948

edits

Navigation menu