1,956
edits
Changes
Jump to navigation
Jump to search
Line 51:
Line 51: +
→Demonstration
#Cut a 5 inch long piece of 1" x 1/8" aluminium.
#Cut a 5 inch long piece of 1" x 1/8" aluminium.
#Roll the piece to the smallest possible radius. This will not be a full ring.
#Roll the piece to the smallest possible radius. This will not be a full ring.
Demonstrate you can safely setup the Ring Roller. You will then proceed to cross cut one of the remaining pieces. Remember to set the blade height so it is protruding less than 1/8" out the top of material for less exposure. When performing a rip cut the fence is used to guide the lumber into the blade. You want to make sure that the distance between the fence and blade is the width of desired cut. Mark the edge of the material when doing a cross cut so you can align the material with the blade in the sled. You can also use a miter gauge for making cross cuts but make sure the material is long enough and well supported.
====General Procedure====
====General Procedure====